PVC Shift Boot for Manual Automatic Car/Auto Gear Shift Knob Cover MT/AT Universal Type(Deep Red)

Previous review to be rescinded. After a conversation with the seller they sent me a new boot. This time around was a much better constructed item. Stitches held up while installing and material stretched correctly. This is not a plug and play boot, it does take some patience, finesse and ability to understand the materials to work, but it does.

I had to cut it to fit in my 05 Acura RSX but it fit and looks great. I lined up the old boot and cut along the ends.

Worked great for my tracker transfer case shifter. Mine was torn up and needed replaced and for a used one the cheapest I could find online was 40 dollars and this was way cheaper and worked great only issue was the metal collar did t go very far down the shaft of the shifter but that's because the shifter is short and tapered but still worked out just couldn't put the knob all the way down. The hole it covered was 5 inches wide and 8 inches long but it could have covered a wider hole no problem still had probably an inch or so it could cover.

Looked good, made well. Did not work in my 2012 KIA at all. Did not fit.

I still think it was worth the price but I couldn't make it work for my GTI.

If you are looking for a stiff, poorly stitched vinyl shift boot... this one is for you!

Didn’t fit. Horrible stitching.

This shift boot was thicker than my stock shift boot and did not fit when we installed it. We were not able to use it.